PMOD-proto-board

A prototyping PMOD. Both 2x6 connectors drop all eight IO lines onto test points, so you can wire up a quick circuit on a standard PMOD footprint without a custom board.

What's on the board

• Two 2x6 PMOD connectors.
• Sixteen IO test points (IO1-IO8 per side).
• 3.3V and GND test points.
• A 470R resistor and blue LED for power.
• A 10uF decoupling cap.

The wiring

Each PMOD socket's eight IO pins route straight to individual test points. Solder a jumper, component or probe to one and it connects to that PMOD pin. 3.3V and GND are broken out alongside. Every line gets a test point; you never have to hunt for a signal.